Code Search

Please fill the "Code Box" to find engine fault code.

Car Models :

Please select your car.

How To Clear Check Engine Lights ?

Ways to clear check engine light on car panel.

Check Engine Light Dictionary

Ways to clear check engine light on car panel.

P3951 Engine Trouble Code

Meaning of P3951 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P3951 Fault Symptoms :

Check engine light comes on
Engine stalling or misfiring
Engine performance issues
Car not starting

If one of these reasons for P3951 code is occuring now you should check P3951 repair processes.
Now don't ask yourself; What should you do with P3951 code ?
The solution is here :

P3951 Possible Solution:

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P3951 Code Meaning :

P	3	9	5	1
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine	Ignition System Or Misfire	Injector Circuit Malfunction - Cylinders	Cylinder 1 Injector Circuit Low	Crankshaft Position Sensor A Circuit Low Input

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P3951 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P3951 engine trouble code is about Crankshaft Position Sensor A Circuit Low Input.

Main reason For P3951 Code

The reason of P3951 OBD-II Engine Trouble Code is Injector Circuit Malfunction - Cylinders.

P3951 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

	Example: 0140